top of page

Mirror Adjustment Instructions - Skeleton Hand Mirrors

Updated: Nov 14, 2020

Adjustment Guide For Skeleton Hand Mirrors

Thank you for your purchase of Image Motorcycle Products mirrors. They are cast in 17-4 stainless steel and hand polished. The dark areas you see are there by design. They give the product more of a three dimensional appearance, however, if you do not like the addition depth the black achieves, you may remove some of the black by soaking a soft cloth in paint thinner and wiping away the desired amount. THESE MIRRORS ARE HAND MADE INDIVIDUALLY ONE AT A TIME. THE SURFACE WILL SHOW HAND WORKING AND SLIGHT VARIATIONS MAY BE VISIBLE.

Due to the overall design of the product, adjustments should be limited. Repeated adjustments will, of course, loosen the screw and may allow the mirrors to easily move when riding. To adjust the mirrors up or down, please grasp the mirrors and move them accordingly. Please note they may seem fixed please, but will allow minor adjustments up or down, go ahead and forcefully adjust them. They won't break. If you can't get the adjustment you want further adjustments can be made by removing the socket head cap screws, removing the talon from the arm and loosening the 8-32 screw at the top of the arm, removing the mirror from the arm and loosening the screw holding the small wrist piece to the hand. Adjust while loose, then remove hand again, tighten with thread locker.

Additional mirror glass is available at $15 a set plus shipping.

31 views0 comments


Commenting has been turned off.
bottom of page